How to Remove Epson Printer Cartridge?

Removing and Installing Epson Cartridges

Ensure you have your substitution cartridges helpful before you start. You should put in new cartridges following expelling the old ones.

Alert:

Leave your old cartridges in the printer until you are prepared to supplant them to forestall the print head spouts from drying out. Try not to open ink cartridge bundles until you are prepared to introduce the ink. Cartridges are vacuum pressed to look after dependability.

1. Turn on your product.
2. Raise up the scanner unit.

1. Caution:
2. Try not to move the print head by hand; else, you may harm your item. Try not to contact the level white link inside the printer.
3. Press the
4. stop button.
5. In the event that a cartridge is low or consumed, the print head moves that cartridge to the pointer position. Press the
6. stop button again to check for extra-low or used cartridges. At the point when the sum total of what cartridges have been recognized, the print head moves to the substitution position.

• On the off chance that no cartridges are low or exhausted, the print head doesn’t move. In the event that you need to supplant a cartridge before it is low or consumed, press the
• stop button for 6 seconds. The print head moves to the substitution position.

1. Squeeze the tab on the cartridge and lift the cartridge straight up to remove it.

1. Note: Dispose of utilized cartridges cautiously. Try not to dismantle the utilized cartridge or attempt to top off it.
2. Cautioning: If ink jumps on your skin, wash it completely with cleanser and water. On the off chance that ink gets at you, flush them promptly with water. In the event that ink gets into your mouth, let it out and see a specialist immediately. Keep ink cartridges out of the span of kids.
3. Before opening the new cartridge bundle, shake it tenderly four or multiple times.

1. Alert:
2. Try not to shake the cartridges subsequent to opening the bundles, or ink may spill.
3. Expel the cartridge from the bundle.
4. Alert:
5. Try not to contact the green chip or the little window on the cartridge. Introduce the new cartridge following expelling the bygone one; in the event that you don’t, the print head may dry out and be not able print.

Remove the yellow line from the top of the cartridge.

1. Warning:
2. Do not remove any other trademarks or seals, or ink will leak.
3. Inject the new cartridge into the handle and push it down until it clicks into position.

1. Lower the scanner unit.

1. Press the

1. stop button. The print head moves to its home position and the printer starts charging the ink. This takes about 1.5 minutes. When the

1. power light stops flashing and remains on, ink charging is finished.
2. Caution:
3. Never turn off the product while the power light is flashing or you will waste ink.
4. Note: If the

1. ink light is on after the print head transfers to its home position or the

1. control light is as yet blazing 3 minutes in the wake of supplanting a cartridge, an ink cartridge may not be introduced appropriately. Press the

1. a stop button, at that point, presses the ink cartridge down until it fits properly.
2. In the event that you expel a low or consumed ink cartridge, you can’t re-introduce and utilize the cartridge.

Caution:

On the off chance that you expel an ink cartridge for later use, shield the ink supply territory from earth and residue and store it in a similar situation as the printer. The valve in the ink supply port is intended to contain an overabundance ink, however, don’t contact the ink supply port or encompassing territory. Continuously store ink cartridges with the name looking up; don’t store cartridges topsy turvy.